gaqev.blogg.se

Ready light must be on or flashing when all protected zones and sensors are secure. Listed below are the steps to arm in the PARTIAL Mode:

PARTIAL is used when the user is inside the premise and wants protection around the perimeter. The user may wish to press the  key to start the exit delay again or disarm and rearm the system if more time is needed. NOTE: The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to the user that the exit time is about to expire. The armed and exit lights will illuminate. Step 2 Enter your 4 or 6 digit user code to arm the system. If the power light is off, you have no AC power.

The security system will not arm if the ready light is not on or flashing. NOTE: If any zones are bypassed, a sensor in that zone can be violated without affecting the ready light. Ready light will be on or flashing when all protected zones and sensors are secure. Step 1 Close all protected doors and windows. Listed below are the steps to arm in the ON Mode: ON is used when the user is away from the premise and wants the interior protected.